Is "fine-tuning" necessary for every deployment and every link?

Modified on Fri, 23 Sep, 2022 at 1:44 PM

Yes, it is essential to run the "fine-tuning" (or calibration) process for every Centauri link, during deployment. Fine-tuning modifies the signal strength of paired devices to optimise the power used for sending and receiving data.

As of version 4.1+ (September 2022) of the Device Management and Deployment App, fine-tuning can be initiated after logging into the DMD app on a CENTAURI device.

When performing calibration, fine-tuning must be run from each of the two CENTAURI devices in a link. The process must be initiated for each device after logging into the DMD app, and should be performed sequentially, one device at a time.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article